Pitney Bowes Relay 5000 Operator's Manual page 173

Adjusting the
Scan Heads
for Ladder or
2D Orientation
Marks (continued)
SV63136 Rev. A
8. Use the blue thumbwheel to move the scan head. Move the thumbwheel
until the pointer lines up with the measurement (distance from the center
of the page to the center of the mark) defined earlier.
Figure 8.1: Use the Blue Thumbwheel to
Adjust Scan Head Position
NOTE: The scanning area on your system may appear different, but operation
concepts are the same.
Figure 8.2: Use the Pointer to Ensure Correct
Scan Head Position
NOTE: The scanning area on your system may appear different, but operation
concepts are the same.
9. If additional scan heads are to be used, repeat step 1 to 8 for each.
10. To verify the adjustment is correct:
a. From the home screen, select Loading Instructions and Pre-Run
Adjustments>canner Setup.
b. Use the UP/DOWN arrow keys to select a feeder to run.
c. Press TRIAL PIECE to feed a piece from the highlighted feeder.
d. Select Finish when done.
Blue thumbwheel
Move thumbwheel until pointer lines up
with the distance measured in Step 4.
Scanning • 8
8-27