Pitney Bowes Relay 5000 Operator's Manual page 62

3 • Basic Operation
Loading
the HCEF
(continued)
3-18
3. Place the envelope, bottom edge
first, into the separator so the top
edge (flap crease) lines up with the
edge of the tab on the Wedge.
NOTE: The edge of the tab is indi-
cated by two arrows.
4. Lower the separator completely, then
push down on the separator gap le-
ver to lock it into place.
5. Pull the envelope out from the HCEF.
Figure 3.8.3: Envelopes Lined Up with Tab on Wedge.
6. Shingle a .7 to 2-inch (20mm to 50mm) stack of envelopes. Place the
envelopes into the HCEF flap side down, flap last.
7. Finish loading a full stack of envelopes (up to 500 pieces), making
sure that the envelopes contact the back of the side guides. It is not
necessary to shingle the remaining envelopes.
NOTES:
• If an HCSF or attached printer is present, you may need to adjust guides
to ensure sheets feed correctly. Refer to Adjusting the HCSF Guides or
Adjusting the Printer Interface Guides in Chapter 7 of this guide for more
information.
• If you are using scanning, you may need to adjust the scan head to ensure
the bar code or OMR mark is read. Refer to Adjusting the Scan Heads in
Chapter 8 of this guide for more information.
SV63136 Rev. A