Pitney Bowes Relay 5000 Operator's Manual page 127

Outer Envelopes
(continued)
SV63136 Rev. A
Envelope Curl/Warp
• An envelope placed flap up on a flat surface under its own weight shall
have no corner raised more than 0.5 inch (13 mm) from the surface.
• Curl/Warp of the envelope flap shall not exceed 1/8 inch (3 mm)
measured while holding flap on flat surface at the crease line.
Letter-Sized Envelope Specifications
Parameter
Width
Depth
Throat Depth*
Paper Weight
Flap Depth
*See Envelope Throat Definitions in this chapter for more information.
Feeder Tower - Flat-Sized Envelope Specifications
Parameter
Width
Depth
Throat Depth
Paper Weight
Flap Depth
Minimum Value
Feeder Tower: 6.37" (162 mm)
HCEF: 8.9" (225 mm)
Feeder Tower: 3.5" (89 mm)
HCEF: 3.9" (98 mm)
0.25" (6.35 mm)
18 lb. (70 gsm)
1.2" (30 mm)
Minimum Value
6.37" (162 mm)
6.5" (165 mm)
0.25" (6.35 mm)
20 lb. (80 gsm)
1.2" (30 mm)
Specifications • 6
Maximum Value
Feeder Tower: 10.5" (266 mm)
HCEF: 10.4" (264 mm)
6.5" (165 mm)
1.49" (38 mm), executive 1.61"
(41 mm)
24 lb. (90 gsm)
2.5" (63 mm) within +/- 1/4" (35
mm) of Center
1.85" (47 mm) outside +/- 1.4"
(35 mm) off center
Maximum Value
10.5" (266 mm)
13" (330 mm)
1.49" (38 mm)
24 lb. (90 gsm)
2.5" (63 mm)
6-9