Requirements For The Fresh Water Connection; Requirements For The Waste Water Connection; Emergency-Off; Chemicals For The Operation Of The Appliance - Meiko EcoStar 545D-M Operating Instructions Manual

Operating instructions EcoStar 545 D-M
ATTENTION!
ATTENTION!
Datei:1_EcoStar545D-M_9662798_Betriebsanleitung_EN_2009-05.doc
MEIKO Maschinenbau GmbH & Co. KG, Postfach 2040, D-77652 Offenburg, Tel.: +49/781/203-0, Fax: +49/781/203-1121
6.5

Requirements for the fresh water connection

Each appliance carries the DVGW test symbol and does not require an extra safety
valve in the water feed.
•
Fresh water connection must be made according to EN 1717 or according to lo-
cal regulations.
The minimum flow pressure of the clean water supply upstream of the solenoid
valve must be 0,6 bar and if water-softening equipment (EW 10) is incorporated
into the machine: 3bar.
The maximum pressure must not exceed 5 bar
•
If the flow pressure is below the minimum, increase the flow pressure with a
booster pump; if the maximum pressure is exceeded, limit it with a pressure re-
ducer.
•
Suitable protective measures must be taken to ensure that no iron particles can
enter the appliance via the mains water supply. Similarly, precautions must be
taken to prevent the entry of other metal particles, for example copper turnings.
Corresponding instructions are contained in the installation drawing. Therefore
suitable measures must be taken.
•
A dirt trap must be fitted into the fresh water supply to protect the solenoid valve.
6.6

Requirements for the waste water connection

•
Build an odour trap into the waste water connection if this is not already built-in
(further information about this is in the Installation drawing / Technical Sheet).
•
The drain hose must be connected to the waste water pipe in the building.
•
A grease trap may be needed, depending on the machine application.
6.7

Emergency-off

•
Set the local main switch to „OFF" or switch off the local main fuse.
6.8

Chemicals for the operation of the appliance

Only alkali detergents and acid rinse agents suitable for use in commercial dish-
washers may be used. Corresponding information is submitted by the manufacturers
of such products.
MEIKO recommends brand cleaning products from leading manufacturers. - clean-
ing and hygiene products
If unsuitable products are used, the life expectancy of the dosing units can be re-
duced considerably.
Observe the dosing instructions of the manufacturer.
Detergents and rinse-aids can present a health hazard if they are not correctly used.
Please observe the manufacturers' instructions on the original packing and on the
safety data sheets.
If a de-scaling agent is used, please strictly observe the manufacturer's instructions
reg. handling and safety. After having used such an agent, the product must be
completely removed from the machine, as even small residues are sufficient to de-
stroy plastic parts and packing materials.
Chemical product settings
The correct settings for the quantity of detergent and rinse agent depend on the prod-
uct used.
The relevant chemical supplier can install the correct setting.
Update:2009-12-18 MRL
W e reserve the right to change execution and construction!
are an excellent choice.
12/42
9662798