Uninstall; Power Source; External Power Source - Teldat iM8 Installation Manual

3 Components and Power Supply

3.4.2 Uninstall

To remove the device, simply pull it out from the slot where it was inserted. We recommend switching off the equip-
ment before removing the USB device.

3.5 Power Source

The Teldat iM8 router is powered through an external AC/DC power adapter.
The Teldat iM8 may also incorporate a card to inject PoE through the 4 ports of the 8-port Switch. In this case, an-
other external adapter is needed to provide power to PoE module.
Note
This adapter is different from the one used to power the Teldat iM8 router and has a different connect-
or.
Warning
The equipment must be used with the power supply provided by the manufacturer.
Workplace conditions. Main characteristics
• Avoid humid and/or dusty locations.
• Direct exposure to sunlight and other heat sources should be avoided. The device should not be placed amongst
papers, magazines or other elements that could hinder natural air circulation.
• The device should not be placed very close to strong electromagnetic fields (such as speakers, engines, etc.).
• Knocks and/or strong vibrations should be avoided during transport, operation and storage.
Warning
The electric current in power cables, telephone lines and communication cables is dangerous. To pre-
vent electric shocks, before installing, handling or opening the equipment covers, connect and discon-
nect the cables following the steps set forth in

3.5.1 External Power Source

To connect the power supply to the device, please follow the steps set out in
To avoid electric shocks, residual current circulation and other unwanted effects that affect communications, the fol-
lowing is recommended:
Warning
All interconnected communication devices should be plugged to THE SAME GROUNDED POWER
OUTLET, which should at the same time be of good quality (lower than 10 ohms).
Whether the workplace is provided with an uninterrupted power supply system (UPS), regulated supply
or it is independent from the rest (such as lighting, etc.); it is highly recommended that all data devices
should be connected to the same power source. This will avoid operating and premature aging prob-
lems of drivers and other components.
12
Connecting on page 13 andDisconnecting
Connecting
on page 13.
on page 13.
Teldat Router iM8
Teldat S.A.