Control Panel - Control Keys - Danfoss AKD 5001 Manual

If certain threshold values are exceeded, the alarm
and/or warning LED lights up together with a status
and alarm text on the control panel.
The voltage LED is activated when the frequency
converter receives voltage, or 24 V external supply; at
the same time the rear lighting of the display will be on.

Control panel - control keys

The control keys are divided into functions. This means
that the keys between display and indicator lamps
are used for parameter Setup, including choice of
display indication during normal operation.
Keys for local control are found under the
indicator LEDs.
Control key functions
[DISPLAY / STATUS] is used for selecting
the mode of display or for changing back
to Display mode from either the Quick
menu mode or the Menu mode.
[QUICK MENU] is used for programming
the parameters that belong under the
Quick menu mode. It is possible to switch
directly between Quick menu mode and
Menu mode.
[MENU] is used for programming all
parameters. It is possible to switch directly
between Menu mode and Quick menu
mode.
[CHANGE DATA ] is used for changing
the parameter selected either in the Menu
mode or the Quick menu mode.
[CANCEL] is used if a change of the
selected parameter is not to be carried out.
44
AKD 5000
[OK] is used for confirming a change of the
parameter selected.
[+/-] is used for selecting parameter and
for changing the chosen parameter or for
changing the read out in line 2.
[<>] is used for selecting group and to
move the cursor when changing numerical
parameters.
[STOP / RESET] is used for stopping
the motor connected or for resetting the
frequency converter after a drop-out (trip).
Can be selected via parameter 014 to be
active or inactive. If stop is activated, line 2
will flash, and [START] must be activated.
[JOG] overrides the output frequency to
a preset frequency while the key is kept
down. Can be selected via parameter 015
to be active or inactive.
[FWD / REV] changes the direction of
rotation of the motor, which is indicated
by means of the arrow on the display
although only in Local. Can be selected via
parameter 016 to be active or inactive.
[START] is used for starting the frequency
converter after stop via the "Stop" key. Is
always active, but cannot override a stop
command given via the terminal strip.
NB!:
If the keys for local control have been
selected as active, they will remain active
both when the frequency has been set for
Local Control and for Remote Control via parameter
002, although with the exception of [Fwd/rev],
which is only active in Local operation.
NB!:
If no external stop function has been selected
and the [Stop] key has been selected as
inactive, the motor can be started and can only
be stopped by disconnecting the voltage to the motor.
Control panel - display read-outs
The display read-out state can be varied - see the list
below - depending on whether the frequency converter
is in normal operation or is being programmed.
MG.50.R3.02 -