Application Configuration; Setting Of Parameters - Danfoss AKD 5001 Manual

Application configuration

Using this parameter enables the choice of a
configuration (setting) of the frequency converter
that fits the application in which the frequency
converter is to be active.
NB!:
First, the motor nameplate date must be
set in parameters 102-106.

Setting of parameters

Select Speed control, open loop if a normal
speed adjustment without external feedback
S S S S p p p p e e e e e e e e d d d d c c c c o o o o n n n n t t t t r r r r o o o o l l l l , , , , o o o o p p p p e e e e n n n n l l l l o o o o o o o o p p p p : : : :
Parame-
ter:
100 Configuration
200 Output frequency range/direction
201 Output frequency low limit
202 Output frequency high limit
203 Reference/feedback range
204 Minimum reference
205 Maximum reference
Select Process control, closed loop if the application
has a feedback signal that is not directly related to
motor speed (rpm/Hz), but some other unit, such
P P P P r r r r o o o o c c c c e e e e s s s s s s s s c c c c o o o o n n n n t t t t r r r r o o o o l l l l , , , , c c c c l l l l o o o o s s s s e e e e d d d d l l l l o o o o o o o o p p p p ( ( ( ( P P P P r r r r o o o o c c c c e e e e s s s s s s s s P P P P I I I I D D D D ) ) ) ) : : : :
Parame-
ter:
100 Configuration
200 Output frequency range/direction
201 Output frequency low limit
202 Output frequency high limit
203 Reference/feedback range
414 Minimum feedback
415 Maximum feedback
204 Minimum reference
205 Maximum reference
416 Process units
437 Process PID normal/inverse
439 Process PID start frequency
440 Process PID proportional gain
441 Process PID integration time
444 Process PID lowpass filter
MG.50.R3.02 -
AKD 5000
There is a choice of the following configurations:
- Speed control, open loop
- Speed control, closed loop
- Process control, closed loop
- Torque control, open loop
- Torque control, speed feedback
The selection of special motor characteristics can be
combined with any application configuration.
signals is required (the internal slip compensation
is operating) from motor or unit.
Set the following parameters in order shown:
Setting:
Speed control, open loop
Only if [0] or [2] in par. 200
Only if [0] in par. 203
as temperature, pressure, etc. Set the following
parameters in the order shown:
Setting:
Process control, closed loop
Only if [0] or [2] in par. 200
Only if [0] in par. 203
Data value:
[0]
Data value:
[3]
51