Danfoss AKD 5001 Manual page 10

AKD Lon connections:
The Lon card has two connections.
AKD-Connections:
Lon card terminals
AKD terminals
The 3-pole connector for the Lon Communication:
Lon card terminals
Adap-Kool Lon
Connect the Adap-Kool Lon network to the removable
3-postion connector. Be careful to route the network
wires away from the AC power and motor wires.
Commissioning
Upon power up the lower red LED of the double LED's,
next to the Lon connectors will initially be flashing red.
1. Set AKD address in parameter 500 in
the AKD (1 to 60)
2. Wait for about 1 min until the red LED goes
off. (card initialisation)
3. Press one of the service pin buttons
4. Wait for about 2 minutes (upload of
parameters to gateway)
5. Perform a "Net configuration" upload in AKM
and you should now find the AKD. Perform a
"AKC description" upload in AKM
6. Go to menu AKC -> Controllers in AKM and
you should find the AKD
MG.50.R3.02 -
1
(Red +24V) (White or Yellow
TX-, RX-)
12
1
A
AKD 5000
A 6-pole connector (only 1-4 is used) that connects
to the AKD. Connections are as follows:
2 3
(Black Com)
69 39 or 20
2
B
4
(Green TX+, RX+)
68
3
Shield
9