Danfoss AKD 5001 Manual page 95

(parameter 213), go to max. output frequency
(parameter 202) or stop and activate a trip.
Parameter
no.
515 Reference %
516 Reference Unit
517 Feedback
518 Frequency
520 Current
522 Power, kW
523 Power, HP
524 Motor voltage
525 DC link voltage
526 Motor temp.
527 AKD temp.
528 Digital input
529 Terminal 53, analogue
input
530 Terminal 54, analogue
input
531 Terminal 60, analogue
input
532 Pulse reference
533 External reference %
534 Status word
537 Heat sink temperature
538 Alarm word
539 AKD control word
540 Warning word, 1
541 Extended status word
Hex
557 Motor RPM
558 Motor RPM x scaling
Function:
These parameters can be read out via the serial
communication port and via the display in Display
mode, see also parameters 009 - 012.
Description of choice:
Reference %, parameter 515:
The value shown corresponds to rhe total
reference (sum of digital/analogue/preset/bus/freeze
ref./catch-up and slow-down).
Reference Unit, parameter 516:
Gives the present value of terminals 17/29/53/54/60 in
the unit resulting from the choice of configuration in
parameter 100 (Hz, Nm or rpm) or in parameter 416.
See also parameters 205 and 416, if required.
Feedback, parameter 517:
= factory setting. () = display text [] = value for use in communication via serial communication port
94
Description
(REFERENCE)
(REFERENCE [UNIT])
(FEEDBACK)
(FREQUENCY)
(MOTOR CURRENT)
(POWER (KW)
(POWER (HP)
(MOTOR VOLTAGE)
(DC LNK VOLTAGE)
(MOTOR THERMAL)
(AKD THERMAL)
(DIGITAL INPUT)
(ANALOG INPUT 53)
(ANALOG INPUT 54)
(ANALOG INPUT 60)
(PULSE REFERENCE)
(EXT. REFERENCE)
(STATUS WORD [HEX])
(HEATSINK TEMP.)
(ALARM WORD [HEX])
(CONTROLWORD [HEX])
(WARN. WORD 1)
(EXT. STATUS WORD)
(MOTOR RPM)
(MOTOR RPM X SCALE)
AKD 5000
Display
text
Hz, Nm or rpm
To be selected
via par. 416
Amp x 100
HP (US)
Binary code
Hex code
Hex code
Hex code
Hex code
Hex code
Indicates the status value of terminals 33/53/60 at the
unit/scale selected in parameters 414, 416 and 416.
Frequency, parameter 518:
The value shown corresponds to the actual motor
frequency f (without resonance dampening).
M
Motor current, parameter 520:
The value shown corresponds to the given motor
current measured as a mean value I
The value is filtered, which means that approx. 1.3
seconds may pass from an input value changes
until the data read-out changes values.
Unit Updating
interval
% 80 msec.
80 msec.
80 msec.
Hz 80 msec.
80 msec.
kW 80 msec.
80 msec.
V 80 msec.
V 80 msec.
% 80 msec.
% 80 msec.
2 msec.
V 20 msec.
V 20 msec.
mA 20 msec.
Hz 20 msec.
20 msec.
20 msec.
°C 1.2 sec.
20 msec.
2 msec.
20 msec.
20 msec.
RPM 80 msec.
- 80 msec.
.
RMS
MG.50.R3.02 -