Quick Setup - Danfoss AKD 5001 Manual

24.3% 30.2% 13.8A
50.0 Hz
MOTOR IS RUNNING
In this state, data values for four operating values
are shown at the same time, giving the related
unit, cf. table. In the example, Reference, Torque,
Current and Frequency are selected as variables
in the first and second line.
• Read-out state III:
This read-out state can be held as long as the
[DISPLAY/STATUS] key is pressed. When the
key is released, the system switches back to
Read-out state II, unless the key is pressed for
less that approx. 1 sec., in which case the system
always reverts to Read-out state I.
REF% TORQUE CURR A
50.0 Hz
MOTOR IS RUNNING
This is where parameter names and units for operating
variables in the first and second line are given -
operating variable 2 remains unchanged.
• Display state IV:
This display state can be produced during operation
if another setup is to be changed without stopping
the frequency converter. This function is activated
in parameter 005, Programming Setup.
24.3% 30.2% 13.8A
50.0 Hz
MOTOR IS RUNNING
The selected programming setup number will flash
to the right of the active setup.
Parameter Setup
The AKD 5000 Series can be used for practically
all assignments, which is why the number of
parameters is quite large. Also, this series offers
46
a choice between two programming modes - a
Menu mode and a Quick menu mode.
The former provides access to all parameters. The
latter takes the user through a few parameters
which make it possible in most cases to start
operating the frequency converter.
Regardless of the mode of programming, a change
of a parameter will take effect and be visible both in
the Menu mode and in the Quick menu mode.
Structure for the Quick menu mode versus
the Menu mode
In addition to having a name, each parameter is linked
up with a number which is the same regardless of
the programming mode. In the Menu mode, the
parameters are divided into groups, with the first digit
of the parameter number (from the left) indicating the
group number of the parameter in question.
•
SETUP
1
•

Quick Setup

The Quick Setup starts with pressing the [QUICK
MENU] key, which brings out the following
read-out on the display:
At the bottom of the display, the parameter number
and name are given together with the status/value
of the first parameter under Quick Setup. The first
time the [Quick Menu] key is pressed after the
unit has been switched on, the read-outs always
start at pos. 1 - see table below.
AKD 5000
The quick menu takes the user through a number
of parameters that may be enough to get the
motor to run nearly optimally, if the factory setting
for the other parameters takes the desired control
functions into account, as well as the configuration
of signal inputs/outputs (control terminals).
The Menu mode makes it possible to select
and change all parameters at the user's option.
However, some parameters will be "missing",
depending on the choice of configuration (parameter
100), e.g. open loop hides all the P.I.D. parameters.
QUICK MENU 1 OF 13
50.0 HZ
001 LANGUAGE
ENGLISH
MG.50.R3.02 -