1500 System; S Ection 5.2 C Onfiguring The 1769 Sc -If4Ih In A M Icro L Ogix 1500 S Ystem - Spectrum Controls 1769sc-IF4IH User Manual

Compact i/o isolated hart analog module
Table of Contents

Advertisement

5-2
Compact IO™ Isolated HART Analog Input Module
Section 5.2
Configuring
the 1769sc-IF4IH
in a MicroLogix

1500 System

User' s Manual 0300215-03 Rev. A
For example, to obtain the general status for channel 2 of the module located in slot e, use
address I:e.5/2.
Figure 5-2 (Address Example)
Slot
I:e.5/2
Input File Type
Element
Delimiter
Word
Delimiter
NOTE: The end cap does not use a slot address.
This example takes you through configuring your 1769scIF4IH isolated HART analog
input module with RSLogix 500 programming software, assumes your module is
installed as expansion I/O in a MicroLogix 1500 system, and that RSLinx™ is properly
configured and a communications link has been established between the MicroLogix
processor and RSLogix 500.
It is recommended that a 1764-LRP series C processor with firmware
!
version 5 or higher be used. The LRP processor supports floating point files,
which is required to read floating point data from the IF4IH.
Attention
Start RSLogix and create a MicroLogix 1500 application. The following screen appears:
Word
Bit
Bit
Delimiter

Hide quick links:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the 1769sc-IF4IH and is the answer not in the manual?

Subscribe to Our Youtube Channel

Table of Contents