Chapter 2 Quick Start For Experienced Users; Section 2.1 Before You Begin; Section 2.2 Required Tools And Equipment; Section 2.3 What - Spectrum Controls 1769sc-IF4IH User Manual

Section 2.1
Before
You Begin
Section 2.2
Required
Tools and
Equipment
Section 2.3
What You

Need To Do

User' s Manual 0300215-03 Rev. A
Chapter 2
Quick Start for Experienced
Users
This chapter can help you get started using the 1769sc-IF4IH isolated HART analog
input module. We base the procedures here on the assumption that you have an
understanding of Allen-Bradley controllers. You should understand electronic process
control and be able to interpret the ladder logic instructions required to generate the
electronic signals that control your application.
Because it is a start-up guide for experienced users, this chapter does not contain detailed
explanations about the procedures listed. It does, however, reference other chapters in
this book where you can get more information about applying the procedures described in
each step.
If you have any questions or are unfamiliar with the terms used or concepts presented in
the procedural steps, always read the referenced chapters and other recommended
documentation before trying to apply the information.
Have the following tools and equipment ready:
•
Medium blade or cross-head screwdriver
•
Analog input device
•
Shielded, twisted-pair cable for wiring (Belden™ 8761 or equivalent for voltage and
current inputs)
•
Controller (for example, a MicroLogix™ 1500 or CompactLogix™ controller)
•
Programming device and software (for example, RSLogix 500™ or RSLogix
5000™)
This chapter covers:
1. Ensuring that your power supply is adequate
2. Attaching and locking the module
3. Wiring the module
4. Configuring the module
5. Going through the startup procedure
6. Monitoring module operation