Gvrp - HP A5830 Series Command Reference Manual

Use the undo garp timer leaveall command to restore the default. This may fail if the default is beyond the
valid value range for the LeaveAll timer.
By default, the LeaveAll timer is 1000 centiseconds.
To keep the dynamic VLANs learned through GVRP stable, do not set the LeaveAll timer smaller than its
default value.
Related commands: display garp timer and garp timer leave.
Syntax
garp timer leaveall timer-value
undo garp timer leaveall
View
System view
Default level
2: System level
Parameter
timer-value: Specifies the Leaveall timer (in centiseconds), which must be a multiple of 5 and range from
the maximum Leave timer on the device (exclusive) to 32,765 (inclusive).
Example
# Set the leaveall timer to 2000 centiseconds, assuming that the Leave timer on every port is set to 60
centiseconds.
<Sysname> system-view
[Sysname] garp timer leaveall 2000

gvrp

Description
Use the gvrp command to enable GVRP.
Use the undo gvrp command to disable GVRP.
By default, GVRP is disabled.
Settings in system view take effect globally; settings in Ethernet view or Layer 2 aggregate interface take
effect on the current interface; settings in port group view take effect on all ports in the port group.
To enable GVRP on a port, enable GVRP globally before you enable it on the port.
In interface view, you can use this command on trunk ports only.
You cannot change the link type of a GVRP-enabled trunk port.
Related commands: display gvrp status.
Syntax
gvrp
undo gvrp
198