Port Hybrid Pvid - HP A5830 Series Command Reference Manual

Syntax
port access vlan vlan-id
undo port access vlan
View
Layer 2 Ethernet interface view, port group view, Layer 2 aggregate interface view
Default level
2: System level
Parameter
vlan-id: Specifies a VLAN ID, in the range of 1 to 4094. Verify that the VLAN specified by the VLAN ID
already exists.
Examples
# Assign GigabitEthernet 1/0/1 to VLAN 3.
<Sysname> system-view
[Sysname] vlan 3
[Sysname-vlan3] quit
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] port access vlan 3
# Assign Layer 2 aggregate interface Bridge-Aggregation 1 and its member ports to VLAN 3.
<Sysname> system-view
[Sysname] vlan 3
[Sysname-vlan3] quit
[Sysname] interface bridge-aggregation 1
[Sysname-Bridge-Aggregation1] port access vlan 3

port hybrid pvid

Description
Use the port hybrid pvid command to configure the PVID of the hybrid port.
Use the undo port hybrid pvid command to restore the default.
By default, the PVID of a hybrid port is VLAN 1.
You can use a nonexistent VLAN as the PVID for a hybrid port. If you use the undo vlan command to
remove the PVID of a hybrid port, it does not affect the setting of the PVID on the port.
The configuration made in Layer 2 Ethernet interface view applies only to the port.
The configuration made in port group view applies to all ports in the port group.
The configuration made in Layer 2 aggregate interface view applies to the aggregate interface and its
aggregation member ports:
If the system fails to apply the configuration to the aggregate interface, it stops applying the
configuration to aggregation member ports.
If the system fails to apply the configuration to an aggregation member port, it skips the port and
moves to the next member port.
157