Display Vlan - HP A5830 Series Command Reference Manual

Field
Last clearing of counters
Last 300 seconds input: 0 bytes/sec
0 packets/sec
Last 300 seconds output: 0
bytes/sec 0 packets/sec
0 packets input, 0 bytes, 0 drops
0 packets output, 0 bytes, 0 drops
The brief information of interfaces
under route mode
Link: ADM - administratively down;
Stby - standby
Protocol: (s) - spoofing
Interface
Link
Protocol
Main IP
Description
Cause

display vlan

Description
Use the display vlan command to display VLAN information.
Related commands: vlan.
Description
Time when the reset counts interface vlan-interface command was
last used to clear the interface statistics.
Never indicates the reset counters interface command has never
been used on the interface since the device's startup.
Average rate of input packets in the last 300 seconds (in bps and
pps).
Average rate of output packets in the last 300 seconds (in bps and
pps).
Total number and size (in bytes) of the received packets of the
interface and the number of the dropped packets.
Total number and size (in bytes) of the sent packets of the interface
and the number of the dropped packets.
Brief information about Layer 3 interfaces.
ADM—Interface has been administratively shut down. To recover its
physical state, perform the undo shutdown command.
Stby—Interface is operating as a standby interface. To see the main
interface, use the display standby state command.
If the network layer protocol state of an interface is shown as UP, but
its link is an on-demand link or not present at all, its protocol
attribute includes the spoofing flag (an s in parentheses).
Abbreviated interface name.
Physical link state of the interface:
UP—Link is up.
ADM—Link has been administratively shut down. To recover its
physical state, perform the undo shutdown command.
Protocol connection state of the interface, which can be UP,
DOWN, or UP(s).
Main IP address of the interface.
Description of the interface.
Cause of a DOWN physical link. If the port has been shut down
with the shutdown command, this field displays Administratively. To
restore the physical state of the interface, use the undo shutdown
command.
147