Revision-Level - HP A5830 Series Command Reference Manual

The MSTP statistics information includes the numbers of TCN BPDUs, configuration BPDUs, RST BPDUs
and MST BPDUs sent/received through the specified ports. The STP BPDUs and TCN BPDUs are counted
only for the CIST.
If you specify the interface-list parameter, the reset stp command clears the spanning tree-related statistics
information on the specified ports. Without the parameter, the reset stp command clears the spanning
tree-related statistics on all ports.
Related commands: display stp.
Syntax
reset stp [ interface interface-list ]
View
User view
Default level
1: Monitor level
Parameter
interface interface-list: Clears the MSTP statistics of the ports specified in the format of interface-list = {
interface-type interface-number [ to interface-type interface-number ] }&<1- 1 0>, where &<1- 1 0> indicates
that you can specify up to 10 ports or port ranges.
Example
# Clear the spanning tree-related statistics on ports GigabitEthernet 1/0/1 through GigabitEthernet
1/0/3.
<Sysname> reset stp interface gigabitethernet 1/0/1 to gigabitethernet 1/0/3

revision-level

Description
Use the revision-level command to configure the MSTP revision level.
Use the undo revision-level command to restore the default MSTP revision level.
By default, the MSTP revision level is 0.
The MSTP revision level, the MST region name, and the VLAN-to-instance mapping table of a device
determine the device's MST region. When the MST region name and VLAN-to-instance mapping table
are both the same for two MST regions, they can still be differentiated by their MSTP revision levels.
After configuring this command, run the active region-configuration command to activate the configured
MST region level.
Related commands: instance, region-name, vlan-mapping modulo, display stp region-configuration,
check region-configuration, and active region-configuration.
Syntax
revision-level level
undo revision-level
113