Figure 3-18 Connect the AUX cable
(1) AUX port
(3) AUX cable
(5) DB-25 (male) or DB-9 (male) connector
Connecting Ethernet Cables
Connecting an electrical Ethernet port
Step1
Connect one end of an Ethernet cable to an electrical Ethernet port on the
A6602 and the other end to the Ethernet port on the peer device. Because a 10Base-
T/100Base-TX/1000Base-T fixed electrical Ethernet port supports MDI/MDIX auto-
sensing, you can use a straight-through cable or crossover cable to connect the port.
Step2
Check the status of the LED of the fixed electrical Ethernet port after power-on.
For the status of the LED, see
Table 3-4 Status of the LED
LED
GE0 to GE3
(yellow/green)
Connecting an optical Ethernet port
Follow these steps to connect a 1000 Mbps optical Ethernet port:
Step1
Remove the dust cover from the optical Ethernet port.
Table
3-4.
Color
Off
No link is present.
Solid green
A 1000 Mbps link is present.
Flashing green
Data is being transmitted/received at 1000 Mbps.
Solid yellow
A 10/100 Mbps link is present.
Flashing yellow
Data is being transmitted/received at 10/100 Mbps.
(2) RJ-45 connector
(4) Modem
Status