HP A6602 Installation Manual page 40

Figure 3-16 Connect the RPS DC power cable to the RPS DC output socket
(1) RPS socket
(3) RPS DC power cable
(5) RPS power switch (ON/OFF)
(7) RPS DC output socket
Step8 Turn on the power switch on the router and the RPS power switch.
Step9 Check the status of the OK LED on the RPS front panel. If it is on, the RPS
power works normally.
Connecting Port Cables
Connecting the Console Cable
Follow these steps to connect the console cable:
Step1 Select a configuration terminal.
The configuration terminal can be a standard ASCII terminal with an RS232 serial port, or a
common PC.
Step2 Connect the console cable.
Disconnect the power supply to the router. Connect the RJ-45 connector of the console cable
to the console port on the router, and the DB-9 (female) connector to the serial port on the
configuration terminal.
Step3 Power on the router after verifying the connection.
Verify the connection and power on the router. The configuration terminal displays the startup
banner of the router if the connection is correct. For details, refer to "Router Power-on" in
Chapter 4 "Starting and Configuring the Router".
(2) Connector for the RPS socket
(4) RPS AC input socket
(6) Connector for the RPS DC output socket
(8) RPS