Configuration Fundamentals - HP A6602 Installation Manual

BootWare Size
Flash Size
cfa0 Size
CPLD Version
PCB Version
BootWare Validating...
Press Ctrl+B to enter extended boot menu...
Press Ctrl+B at this prompt to enter the extended BootWare menu. Otherwise, the system
starts to read and decompress the application program.
To enter the extended BootWare menu, press Ctrl+B as prompted within four seconds.

Otherwise, the system will read and decompress the application program.
If you want to enter the extended BootWare menu after the system starts application

decompression, you need to restart the router.
The system defines three types of application files, namely, main application file, backup

application file and secure application file. For details about these three types of application
files, refer to Chapter 5 "Maintaining Software".
For the convenience of reading and understanding, the extended BootWare menu is referred to

as the main BootWare menu unless otherwise specified.
Starting to get the main application file--cfa0:/A6602.bin!..................
......................................................
The main application file is self-decompressing
..........................................................................
..........................................................................
.......
Done!
System is starting.....
User interface con0 is available
Press ENTER to get started.
Press Enter. The screen will display:
<HP>
This prompt indicates that the router has entered user view and is ready to configure.

Configuration Fundamentals

In general, the configuration steps are as follows:
Step1 Before configuring the router, you should summarize the networking requirements, including
the networking objective, role of the router in the network, division of subnets, WAN type and
transmission medium, network security policy and network reliability.
Step2 Based on the above requirements, draw a clear, complete network diagram.
Step3 Configure the WAN interface of the router. First, configure the physical operating parameters
(for example, the operating mode, baud rate and synchronous clock in the case of a serial
interface) of the interface according to the transmission medium of the WAN. Then, configure
the data link layer protocol encapsulated on the interface and related operating parameters.
Step4 Configure the IP addresses of all the interfaces on the router according to the division of the
subnets.
: 1024KB
: 4MB
: 495MB
: 135.0
: Ver.B