HP A6602 Installation Manual page 30

Installing the Router on a Workbench Installing the Router on a Workbench
If a 19-inch rack is not available, you can install the router on a clean workbench. During ch rack is not available, you can install the router on a clean workbench. During ch rack is not available, you can install the router on a clean workbench. During
installation, make sure:
The length and width of the workbench are larger than the distance between the The length and width of the workbench are larger than the distance between the The length and width of the workbench are larger than the distance between the

feet of the router. See feet of the router. See
Table 3-1 Dimensions of the Dimensions of the A6602
Dimensions without feet and mounting brackets (H × Dimensions without feet and mounting brackets (H ×
W × D)
The workbench is steady and well grounded. The workbench is steady and well grounded.

The workbench is solid enough to support the weight of the router and installation The workbench is solid enough to support the weight of the router and installation The workbench is solid enough to support the weight of the router and installation

accessories.
There is a minimum clearance of 10 cm (3.9 in.) around the router for heat There is a minimum clearance of 10 cm (3.9 in.) around the router for heat There is a minimum clearance of 10 cm (3.9 in.) around the router for heat

dissipation of the router chassis. on of the router chassis.
No heavy object is placed on the router for fear of device damage and poor heat No heavy object is placed on the router for fear of device damage and poor heat No heavy object is placed on the router for fear of device damage and poor heat

dissipation.
Installation the Router in a Rack Installation the Router in a Rack
Installing an N68 rack Installing an N68 rack
The A6602 can be installed in an can be installed in an HP N68 rack. For the installation of an N68 rack, refer to
N68 Cabinet Installation and Remodel Introduction N68 Cabinet Installation and Remodel Introduction.
Installing mounting-brackets onto the router
1) Structure of the mounting-brackets Structure of the mounting
Figure 3-2 Structure of mounting Structure of mounting-brackets
(1) Left front mounting-bracket
(3) Left rear mounting-bracket
2) Install the front mounting Install the front mounting-brackets to the router
Before installing the router in the rack, fix the left and right front mounting Before installing the router in the rack, fix the left and right front mounting-brackets
respectively to the left and right sides of the front panel of the router. left and right sides of the front panel of the router.
install them.
Table 3-1 for the dimensions of the router.
Item
brackets onto the router
bracket
bracket
Description Description
44 × 442 × 460 mm (1.73 × 17.4 × 18.1 in.) mm (1.73 × 17.4 × 18.1 in.)
an N68 rack, refer to HP
(2) Right front mounting nt mounting-bracket
(4) Right rear mounting (4) Right rear mounting-bracket
brackets
Figure 3-3 Figure 3 shows how to