Remove the blank panel (if any) from the slot to be used on the SPE card.
3.
Unpack the subcard.
4.
To install a subcard:
Turn the ejector levers of the subcard outward simultaneously with both hands, and then slide
1.
the subcard (with the right side up) straight into the SPE card along the slide rails until the
ejector levers touch the panel of the SPE card, as shown in
Push against the front panel of the subcard. When the front panel is close enough to the SPE
2.
card, pivot the ejector levers of the subcard inward with both hands so that the front panel is
flush with the panel of the SPE card.
Use a Phillips screwdriver to fasten the mounting screws on the subcard.
3.
Figure 15 Installing a subcard
Connecting power cables
Check the following items before connecting power cables:
For lightning protection, the AC power should be routed through an external lightning device
•
into the router. For more information, see
The power switch on the power supply is in the OFF position.
•
Figure
"Lightning
protection."
16
15.