HP A6602 Installation Manual page 79

Select 3 from the file control sub-menu. The system displays the following information:
'M' = MAIN
=========================================================================
|NO. Size(B)
|1 734
|2 760
|3 810
|4 850
|0 Exit
=========================================================================
Enter file No:
Select a file number, which is 1 in this example. The following information appears:
Modify the file attribute:
=========================================================================
|<1> +Main
|<2> -Main
|<3> +Backup
|<4> -Backup
|<0> Exit
=========================================================================
Enter your choice(0-4):
You can set the file attribute to M (main) or B (backup), or cancel the setting by selecting a
choice from 1 to 4.
In this example, 1 is selected and the system changes the file startup.cfg from type N/A to type
M.
Set the file attribute success!
Now, the attribute of the file startup_bak1.cfg has automatically changed from M to N/A.
After selecting 3 from the file control sub-menu, if you select 0 to exit the menu, the system
enters the default mode for the main and backup configuration files, namely the files
cfa0:/main.cfg and/or cfa0:/backup.cfg, if any, are automatically assigned the M and/or B
attributes respectively.
Setting configuration file attributes at the CLI
You can use the startup saved-configuration cfgfile [ backup | main ] command to define the
configuration file to be used for the next boot and its attribute. In this command, use cfgfile
argument to specify the configuration file name.
Note that:
You can use the startup saved-configuration cfgfile main command to change the attribute of

an N/A-type configuration file to M.
You can use the startup saved-configuration cfgfile backup command to change the

attribute of an N/A-type configuration file to B.
You can use the startup saved-configuration cfgfile backup command to change the

attribute of an M-type configuration file to M + B.
You can use the startup saved-configuration cfgfile main command to change the attribute of

a B-type configuration file to M + B.
If you use neither main nor backup in your command, you assign the M attribute to the

specified configuration file.
If you assign the M attribute to a configuration file, the attribute of the existing main

configuration file, if any, is automatically erased, because there can be only one main
configuration file in the system at a time.
'B' = BACKUP
Time
Dec/17/2007 11:47:20 N/A
Dec/17/2007 18:49:50 N/A
Dec/17/2007 18:49:26 M
Dec/17/2007 18:50:08 N/A
'S' = SECURE 'N/A' = NOT ASSIGNED
Type Name
cfa0:/startup.cfg
cfa0:/startup_bak2.cfg
cfa0:/startup_bak1.cfg
cfa0:/startup_bak3.cfg
|
|
|
|
|
|
|
|
|
|
|