Installing A Mim - HP A6602 Installation Manual

Removing a HIM
Follow these steps to remove a HIM: Follow these steps to remove a HIM:
Step1 Position the router so that the rear panel of the router faces you.
Step2 Loosen the captive screws on the HIM with a flat Loosen the captive screws on the HIM with a flat-blade screwdriver.
Figure 6-11 Loosen the captive screws on a HIM
Step3 Grasping the two ejector levers with both hands, pivot the ejector le Grasping the two ejector levers with both hands, pivot the ejector levers outward.
Step4 Pull the HIM out of the slot.
Figure 6-12 Remove the HIM
Before pulling a HIM out of a slot, loosen the two captive screws. Otherwise, the panel of the Before pulling a HIM out of a slot, loosen the two captive screws. Otherwise, the panel of the Before pulling a HIM out of a slot, loosen the two captive screws. Otherwise, the panel of the

HIM may be seriously deformed. HIM may be seriously deformed.
After removing a HIM, place it in an antistatic bag.

If you do not install a new interface module where the HIM was removed, install two blank If you do not install a new interface module where the HIM was removed, install two blank If you do not install a new interface module where the HIM was removed, install two blank

panels to prevent dust from entering the chassis. For the installation procedure, refer to panels to prevent dust from entering the chassis. For the installation procedure, refer to panels to prevent dust from entering the chassis. For the installation procedure, refer to
"Installing a Blank
Installing and Removing a MIM

Installing a MIM

Follow these steps to install a MIM: Follow these steps to install a MIM:
Step1 Position the router so that the rear panel faces you. Position the router so that the rear panel faces you.
Step2 Remove the lower blank panel from the slot where you will install the MIM. For the removal Remove the lower blank panel from the slot where you will install the MIM. For the removal Remove the lower blank panel from the slot where you will install the MIM. For the removal
procedure, refer to
Step3 Gently push the MIM into the slot along the slide rails. Gently push the MIM into the slot along the slide rails.
hat the rear panel of the router faces you.
Loosen the captive screws on a HIM
Remove the HIM
M, place it in an antistatic bag.
Panel" in Page 6 " in Page 6-5.
d Removing a MIM
"Removing a Blank Pan Removing a Blank Panel" in Page 6-5.
vers outward.