HP A6602 Installation Manual page 74

Figure 5-11 Set up an FTP updating environment
Connect the Ethernet interface GigabitEthernet 0/0 on the router to the PC using a crossover Connect the Ethernet interface GigabitEthernet 0/0 on the router to the PC using a crossover Connect the Ethernet interface GigabitEthernet 0/0 on the router to the PC using a crossover

Ethernet cable.
Configure the IP addresses of the server and client to be on the same network segment. In this Configure the IP addresses of the server and client to be on the same network segment. In this Configure the IP addresses of the server and client to be on the same network segment. In this

example, the IP address of interface GigabitEthernet 0/0 is 192.168.80.10, and that of the PC is example, the IP address of in
192.168.80.200.
You can use the ping command to check whether the connection is successful.

You can update the applications of the A6602 through GigabitEthernet 0/0 only. You can update the applications of the
2) Enable the FTP service.
# Enable FTP server.
<HP> system-view
[HP] ftp server enable
# Add FTP username and password. # Add FTP username and password.
[HP] local-user guest
[HP-luser-guest] service-type ftp
[HP-luser-guest] password simple 123456 guest] password simple 123456
[HP-luser-guest] authorization
Table 5-11 Description on the display information of enabling the FTP service
Display information Display information
ftp server enable
local-user guest
service-type ftp
password simple 123456 password simple 123456
authorization-attribute level 3
Set up an FTP updating environment
terface GigabitEthernet 0/0 is 192.168.80.10, and that of the PC is
command to check whether the connection is successful. command to check whether the connection is successful.
type ftp
authorization-attribute level 3
Description on the display information of enabling the FTP service Description on the display information of enabling the FTP service
attribute level 3
through GigabitEthernet 0/0 only.
Enable the FTP server function.
Create a local user, and enter user view. Create a local user, and enter user view.
Set the service type that can be used locally to FTP. Set the service type that can be used locally to
Configure the user password.
Set the user level to 3.
Description Description