Fixed Interfaces - HP A6602 Installation Manual

Table 1-8 Description of rear panel LEDs
LED
GE0 to GE3
(yellow/green)
SFP0 to SFP3
(yellow/green)

Fixed Interfaces

Table 1-9 Fixed interfaces
Fixed interface
Console
AUX
USB interfaces
CF card slot
Combo interfaces
Console port
1) Introduction
The A6602 provides an RS-232 asynchronous serial console port that can be connected to a
computer for system debugging, configuration, maintenance, management, and host software
loading.
2) Technical specifications for the console port
Table 1-10 Technical specifications for the console port
Connector
Status
Off
Solid green
Blinking green
Solid yellow
Blinking yellow
Off
Solid green
Blinking green
Solid yellow
1
1
USB 0: Type A connector, operating in the host mode
2
USB 1: Type B connector, operating in the device mode
The optional CF cards supported by the A6602 are available in three
sizes:
1
256 MB
512 MB
1 GB
Four electrical Ethernet interfaces: GE0 to GE3
Four optical Ethernet interfaces: SFP0 to SFP3
For a Combo interface, the default operating interface is the optical
Ethernet interface.
4
For a Combo interface, you can use either the electrical Ethernet
interface or the optical Ethernet interface at a point of time. You can use
the combo enable { copper | fiber } command in interface view to
switch between the optical and electrical Ethernet interfaces.
Item
RJ-45
No link is present.
A 1000 Mbps link is present.
Data is being received or transmitted at a rate of 1000 Mbps.
A 10/100 Mbps link is present.
Data is being received or transmitted at a rate of 10/100 Mbps.
No link is present.
A 1000 Mbps link is present.
Data is being received or transmitted at a rate of 1000 Mbps.
The system fails to detect the SFP port.
Specification
Specification
Meaning