Installing A Him - HP A6602 Installation Manual

In the case that a HIM is removed, install two blank panels. In the case that a HIM is removed, install two blank panels.

In the case that a MIM is removed, install one blank panel. e that a MIM is removed, install one blank panel.

Step4 Tighten the fastening screws with a Phillips screwdriver. Tighten the fastening screws with a Phillips screwdriver.
Figure 6-8 Install a blank panel
Installing and Removing a HIM Installing and Removing a HIM

Installing a HIM

Follow these steps to install a HIM: Follow these steps to install a HIM:
Step1 Position the router so that the rear panel faces you. sition the router so that the rear panel faces you.
Step2 Remove the two blank panels from the slot where you will install the HIM. For the removal Remove the two blank panels from the slot where you will install the HIM. For the removal Remove the two blank panels from the slot where you will install the HIM. For the removal
procedure, refer to
Step3 Gently push the HIM into the slot along the slide rails, and then push the ejector levers inward Gently push the HIM into the slot along the slide rails,
to lock the HIM in position.
Figure 6-9 Install a HIM
Step4 Fasten the captive screws on the HIM with a flat-blade screwdriver. Fasten the captive screws on the HIM with a flat
Figure 6-10 Fix the HIM
Step5 Check the corresponding slot LED on Check the corresponding slot LED on the front panel. After the HIM is initialized, if the LED is
on, the HIM is correctly installed and operates normally; if the LED is off, the HIM failed the self on, the HIM is correctly installed and operates normally; if the LED is off, the HIM failed the self on, the HIM is correctly installed and operates normally; if the LED is off, the HIM failed the self-
test.
Install a blank panel
"Removing a Blank Panel Removing a Blank Panel" in Page 6-5.
Install a HIM
Fix the HIM
the front panel. After the HIM is initialized, if the LED is
and then push the ejector levers inward