Oracle X7 series Administration Manual page 97

d. In the Transfer Method drop-down list, select a transfer method.
e. Specify the location of the XML file.
f. If you specified a Passphrase when you exported the XML file, enter and
confirm the Passphrase.
If you included fault data in the backup, you can select Include Fault Data to restore
it. This selection is reserved for Oracle Service personnel when they replace the SP. It
requires a passphrase.
Click Run.
g.
While the Restore operation is taking place, Oracle ILOM sessions are suspended. The
Note -
sessions resume after the Restore operation is complete.
2. To restore a saved Oracle ILOM configuration in the Oracle ILOM command-line
interface (CLI):
a. Log in to the Oracle ILOM CLI.
For instructions, see
b.
Use the set command:
set /SP/Config passphrase=passphrase include_faultdata=[true|false]
load_uri=transfer_method://username:password@host/filepath
Where:
passphrase is the passphrase you specified when you exported the XML file. If you
■
did not specify a passphrase, do not set the passphrase property.
include_faultdata=true includes fault data in the restore, if fault data was included
■
in the backup. This selection requires a passphrase and is available with Oracle ILOM
3.2.6 or newer.
The fault data backup and restore is reserved for Oracle Service personnel when
Note -
they replace the SP.
transfer_method is one of the following protocols: tftp, ftp, sftp, scp, http, or
■
https.
Restore a Saved Oracle ILOM Firmware Configuration (Oracle ILOM)
"Accessing Oracle ILOM" on page
Backing Up and Restoring Hardware and Firmware Configurations
21.
97