Table of Contents
Advertisement
Accessing Oracle Hardware Management Pack
Note -
e.
When you are done, disable redirection by typing:
set /SP/services/kvms/host_storage_device/ mode=disabled
Related Information
Redirecting a Remote Image File, Oracle ILOM Administrator's Guide for Configuration
■
and Maintenance, Firmware Release 4.0.x at http://www.oracle.com/goto/ilom/docs.
Accessing Oracle Hardware Management Pack
Before using Oracle Hardware Management Pack, you must install it (unless you are running
Solaris 11.2 or newer), and you must install an operating system. After that, you can run Oracle
Hardware Management Pack commands from the operating system command line, and you can
configure and use the management agents.
For installation instructions, see:
"Installing Oracle Hardware Management Pack" on page 32
■
Oracle Hardware Management Pack Installation Guide
■
To get started, see the following procedures:
"Use Oracle Hardware Management Pack Commands " on page 33
■
"Use the Oracle Hardware Management Pack Management Agents" on page 34
■
Installing Oracle Hardware Management Pack
To install Oracle Hardware Management Pack, you must download the installation files
from My Oracle Support. Then, you can run a graphical installer or install Oracle Hardware
Management Pack components manually.
Note -
operating system and is called Oracle Hardware Management Pack for Oracle Solaris. Do not
download and use any version of Oracle Hardware Management Pack that is not specifically
qualified for the Oracle Solaris operating system.
32
Oracle X7 Series Servers Administration Guide • September 2017
Redirection is active is the status if set to either Operational or Connecting.
Oracle Hardware Management Pack is an integrated component of the Oracle Solaris
Advertisement
Chapters
Table of Contents
