Resetting The Firmware To Default Settings; Reset Bios Firmware To Default Settings (Bios) - Oracle X7 series Administration Manual

Resetting the Firmware to Default Settings

raidconfig import config filename.xml
Oracle Hardware Management Pack updates any unconfigured RAID controllers with the
information in the XML file.
Related Information
Exporting or Importing a RAID Controller Configuration (raidconfig), Oracle Hardware
■
Management Pack Server CLI Tools User's Guide at
docs
Resetting the Firmware to Default Settings
Recover from unwarranted configuration changes by resetting the BIOS or Oracle ILOM
configuration to its factory default configuration. For instructions, see the following procedures:
"Reset BIOS Firmware to Default Settings (BIOS)" on page 100
■
"Reset BIOS Firmware to Default Settings (Oracle ILOM)" on page 101
■
"Reset BIOS Firmware to Default Settings (Oracle Hardware Management
■
Pack)" on page 102
"Reset Oracle ILOM Firmware to Default Settings (Oracle ILOM)" on page 102
■
"Reset Oracle ILOM Firmware to Default Settings (Oracle Hardware Management
■
Pack)" on page 103

Reset BIOS Firmware to Default Settings (BIOS)

Setting defaults ensures that the server is operating with a configuration that is known to be
good.
Note -
installed, then BIOS is probably already configured to its default settings.
Any changes you make in the BIOS Setup Utility using the F2 key are permanent until the next
time you change them.
Ensure that your server is equipped with a properly installed hard disk drive (HDD) or solid
Before You Begin
state drive (SSD).
100 Oracle X7 Series Servers Administration Guide • September 2017
If the server is newly installed and this is the first time an operating system is being
http://www.oracle.com/goto/ohmp/