Set The Sp Clock (Oracle Hardware Management Pack) - Oracle X7 series Administration Manual

To synchronize the service processor clock with an NTP server, do the
■
following:
i Select the Enabled check box in the Synchronize Time Using NTP
field.
ii Enter the IP address or hostname of one or more NTP servers.
Click Save.
iii
2. To set the service processor clock from the Oracle ILOM command-line interface
(CLI):
a. Log in to the Oracle ILOM CLI.
For instructions, see
b. Configure the service processor clock manually, or enable the clock to
synchronize with an NTP server:
To set the service processor clock manually, use the
■
set /SP/clock datetime= MMDDhhmmYYYY timezone=3_to_4_characters
To synchronize the service processor clock with an NTP server, use the
■
command:
set
set /SP/clock usentpserver=enabled
set /SP/clients/ntp/server/[1|2] address=address
Related Information
Setting Properties for SP or CMM Clock, Oracle ILOM Administrator's Guide for
■
Configuration and Maintenance, Firmware Release 4.0.x at
goto/ilom/docs
Set the SP Clock (Oracle Hardware Management
Pack)
1. Access the operating system command-line with root privileges.

Set the SP Clock (Oracle Hardware Management Pack)

"Accessing Oracle ILOM" on page 21.
command:
set
http://www.oracle.com/
Configuring Oracle ILOM 69