Oracle X7 series Administration Manual page 92

Back Up the Current Oracle ILOM Firmware Configuration (Oracle ILOM)
g. Click Run.
To back up the current Oracle ILOM configuration in the Oracle ILOM command-
2.
line interface (CLI):
a. Log in to the Oracle ILOM CLI.
For instructions, see
Use the
b.
set /SP/config passphrase=passphrase include_faultdata=[true|false] dump_uri=
transfer_method://username:password@host/filepath
Where:
■
■
■
■
■
■
Note -
password.
Related Information
Back Up the Oracle ILOM Configuration File, Oracle ILOM Administrator's Guide for
■
Configuration and Maintenance, Firmware Release 4.0.x at
goto/ilom/docs
92 Oracle X7 Series Servers Administration Guide • September 2017
"Accessing Oracle ILOM" on page
command:
set
passphrase is a passphrase used to encrypt sensitive data in the backup file. If you
specify a passphrase, the passphrase is required to restore the backed up configuration.
If you do not specify a passphrase, sensitive data is not included in the backup file.
include_faultdata=true includes fault data in the backup. The default is false.
The fault data backup and restore is reserved for Oracle Service personnel when
Note -
they replace the SP. It is available with Oracle ILOM 3.2.6 or newer.
transfer_method is one of the following protocols: tftp, ftp, sftp, scp, http, or
https.
username and password are your credentials on the remote system where the backup
file will be saved.
host is the IP address or hostname of the system where the backup file will be saved.
filepath is the relative path to the backup file.
If you transfer the backup file using TFTP, you do not need to provide a username or
21.
http://www.oracle.com/