Bring Your Smart2Pure System Into Operation - Thermo Scientific Smart2Pure 3 Operating Instructions Manual

Bring your Smart2Pure system into operation

Step Action
1 Place the Smart2Pure system at the desired location (on
the workbench, under the workbench, or wall-mount).
A wall attachment kit is available for wall-mounting
(purchasing separately).
2 Remove the cover from the ultrapure cartridge by
pressing the snapper and pull the cover off towards the
front.
3 a. Locate the ultrapure cartridge.
b. Place the ultrapure cartridge in the rear section
of the system and insert the two quick
connectors into the ultrapure cartridge. When
you hear an audible click you can be sure that
the quick connectors have been inserted
correctly.
The quick connectors are attached to the system in such
a manner so as to prevent installing the ultrapure
cartridge incorrectly.
Thermo Scientific
• After Installation all tubings have to be checked for their correct position on the
systems panel and that is no leakage after open the feedwater supply.
• 09.4000 is a required pre-filter system (see
page 17)
• To avoid tripping, ensure that the tubings and wires do not lay over the floor.
Connections of the Smart2Pure 12 system
"Feedwater requirements"
Figure
See Section "Wall mounting"
Snapper
Cover
b.)
7
Installation
on
on page 42.
Quick
connectors
Ultrapure
cartridge
Smart2Pure
31