Wall Mounting - Thermo Scientific Smart2Pure 3 Operating Instructions Manual

7
Installation
Connections of the Smart2Pure 12 system

Wall mounting

Step Action
1 Use the wall-mounting brackets to mark the
anchoring points with a pen on the wall at the
location where the holes are to be drilled for the
wall-mounting bracket.
Use an 8 mm/ 0.31 inch drill bit to drill the holes.
2 Insert the three S8 Nylon anchors into the holes and
then use the three wood screws to firmly screw the
wall-mounting brackets into place.
3 Lift the system and hang the back of it on the
wall-mounting brackets.
Always lift and carry the system in tandem (two
people), never alone. Lift the system at the two
bottom corners.
Smart2Pure
42
You can also mount your Smart2Pure 3/6 or Smart2Pure 12 system on the wall. To
do this, use the wall-mounting fixture included in the accessories (purchased
separately Item No.: 09.2212). Before you begin mounting the system on the wall
you must check the strength of the wall to ensure that it is suitable for supporting the
system (see "Dimensions and weight Smart2Pure 3/6"
and weight of Smart2Pure12"
The screws and anchors supplied with the wall-mounting brackets are only suitable
for attaching the wall-mounting brackets to a concrete wall or a solid (masonry) wall.
on page 19 for the system).
Figure
See figure below.
mm/ 7.48 inch
mm/ 3.74 inch
on page 18 and "Dimensions
Thermo Scientific