Electromagnetic Compatibility (Emc) Information - Vatech PaX-i3D Smart User Manual

13. Appendices

13.3 Electromagnetic Compatibility (EMC) Information

Guidance and manufacturer's declaration - electromagnetic emissions.
The model PaX-i3D Smart(PHT-30LFO) is intended for use in the electromagnetic environment
specified below. The customer or the user of the model PaX-i3D Smart(PHT-30LFO) should
assure that it is used in such an environment.
Emissions test
RF emissions
Group 1
CISPR 11
Class A (The model PaX-
RF emissions i3D Smart(PHT-30LFO)
CISPR 11 in combination with the
shielded location)
Harmonic
emissions IEC Not applicable
61000-3-2
Voltage
fluctuations /
Not applicable
flicker emissions
IEC 61000-3-3
NOTE) It is essential that the actual RF shielding effectiveness and filter attenuation of the
shielded location be verified to ensure that they meet or exceed the specified minimum values.
Compliance Electromagnetic environment - guidance
The model PaX-i3D Smart(PHT-30LFO)
uses RF energy only for its internal function.
Therefore, its RF emissions are very low and
are not likely to cause any interference in
nearby electronic equipment.
The model PaX-i3D Smart(PHT-30LFO)
must be used only in a shielded location
with a minimum RF shielding effectiveness
and, for each cable that exits the shielded
location, a minimum RF filter attenuation
of 20 dB from 30 MHz to 230 MHz, 20
dB from 230 MHz to 1 GHz. The model
PaX-i3D Smart(PHT-30LFO) , when
installed in such a shielded location, is
suitable for use in all establishments
other than domestic, and may be used in
domestic establishments and those directly
connected to the public low-voltage power
supply network that supplies buildings used
for domestic purposes.
139 I
PaX-i3D Smart