HP MSR ASM Configuration Manual page 117

Device
Router D
Source 1
Source 2
Receiver 1
Receiver 2
Configuration procedure
1. Assign IP addresses and configure unicast routing:
a. Assign an IP address and subnet mask to each interface according to
shown.)
b. Configure OSPF on the routers in the BIDIR-PIM domain to make sure they are interoperable at
the network layer. (Details not shown.)
2. Enable IP multicast routing, PIM-SM, BIDIR-PIM, and IGMP:
# On Router A, enable IP multicast routing, enable PIM-SM on each interface, and enable
BIDIR-PIM.
<RouterA> system-view
[RouterA] multicast routing-enable
[RouterA] interface ethernet 1/1
[RouterA-Ethernet1/1] pim sm
[RouterA-Ethernet1/1] quit
[RouterA] interface serial 2/1
[RouterA-Serial2/1] pim sm
[RouterA-Serial2/1] quit
[RouterA] pim
[RouterA-pim] bidir-pim enable
[RouterA-pim] quit
# On Router B, enable IP multicast routing, enable PIM-SM on each interface, enable IGMP on
interface Ethernet 1/1, and enable BIDIR-PIM.
<RouterB> system-view
[RouterB] multicast routing-enable
[RouterB] interface ethernet 1/1
[RouterB-Ethernet1/1] igmp enable
[RouterB-Ethernet1/1] pim sm
[RouterB-Ethernet1/1] quit
[RouterB] interface serial 2/1
[RouterB-Serial2/1] pim sm
[RouterB-Serial2/1] quit
[RouterB] interface serial 2/2
[RouterB-Serial2/2] pim sm
[RouterB-Serial2/2] quit
[RouterB] pim
[RouterB-pim] bidir-pim enable
[RouterB-pim] quit
Interface
Serial 2/1
—
—
—
—
105
IP address
10.110.3.2/24
192.168.1.100/24
192.168.4.100/24
192.168.2.100/24
192.168.3.100/24
Figure 34. (Details not