HP MSR ASM Configuration Manual page 355

Device
Router D
Router D
Router D
Router D
Configuration procedure
1. Enable IPv6 forwarding on each router and assign an IPv6 address and prefix length to each
interface according to
2. Configure OSPFv3 on the routers in the IPv6 PIM-DM domain to make sure they are interoperaable
at the network layer. (Details not shown.)
3. Enable IPv6 multicast routing, and enable IPv6 PIM-DM and MLD:
# Enable IPv6 multicast routing on Router A, and enable IPv6 PIM-DM on each interface and
enable MLD on Ethernet 1/1, which connects Router A to N1.
<RouterA> system-view
[RouterA] multicast ipv6 routing-enable
[RouterA] interface ethernet 1/1
[RouterA-Ethernet1/1] mld enable
[RouterA-Ethernet1/1] pim ipv6 dm
[RouterA-Ethernet1/1] quit
[RouterA] interface serial 2/0
[RouterA-Serial2/0] pim ipv6 dm
[RouterA-Serial2/0] quit
# Enable IPv6 multicast routing, and enable IPv6 PIM-DM and MLD on Router B and Router C in the
same way. (Details not shown.)
# On Router D, enable IPv6 multicast routing and enable IPv6 PIM-DM on each interface.
<RouterD> system-view
[RouterD] multicast ipv6 routing-enable
[RouterD] interface ethernet 1/1
[RouterD-Ethernet1/1] pim ipv6 dm
[RouterD-Ethernet1/1] quit
[RouterD] interface serial 2/0
[RouterD-Serial2/0] pim ipv6 dm
[RouterD-Serial2/0] quit
[RouterD] interface pos 5/0
[RouterD-Pos5/0] pim ipv6 dm
[RouterD-Pos5/0] quit
[RouterD] interface pos 5/1
[RouterD-Pos5/1] pim ipv6 dm
[RouterD-Pos5/1] quit
Verifying the configuration
Use the display pim ipv6 interface command to display IPv6 PIM information on each interface. For
example:
# Display IPv6 PIM information on Router D.
Interface
Ethernet 1/1
Serial 2/0
POS 5/0
POS 5/1
Figure 95. (Details not shown.)
343
IPv6 address
4001::1/64
1002::2/64
2002::2/64
3001::2/64