HP MSR ASM Configuration Manual page 204

Device
Router B
Router B
Router B
Router B
Router C
Router C
Router D
Router D
Router D
Router D
Router D
Router D
Router E
Router E
Configuration procedure
1. Assign IP addresses and configure unicast routing:
a. Assign an IP address and subnet mask to each interface according to
shown.)
b. Configure OSPF on the routers in the PIM-SM domain to make sure the routers are
interoperable at the network layer and they can dynamically update routing information.
(Details not shown.)
2. Enable IP multicast routing, and enable PIM-SM and IGMP:
# Enable IP multicast routing on Router B, enable PIM-SM on each interface, and enable IGMP on
the host-side interface Ethernet 1/1.
<RouterB> system-view
[RouterB] multicast routing-enable
[RouterB] interface ethernet 1/1
[RouterB-Ethernet1/1] igmp enable
[RouterB-Ethernet1/1] pim sm
[RouterB-Ethernet1/1] quit
[RouterB] interface serial 2/0
[RouterB-Serial2/0] pim sm
[RouterB-Serial2/0] quit
[RouterB] interface pos 5/0
[RouterB-Pos5/0] pim sm
[RouterB-Pos5/0] quit
[RouterB] interface loopback 0
[RouterB-LoopBack0] pim sm
[RouterB-LoopBack0] quit
[RouterB] interface loopback 10
[RouterB-LoopBack10] pim sm
Interface
POS 5/0
Loopback 0
Loopback 10
Loopback 20
POS 5/0
POS 5/1
Ethernet 1/1
Serial 2/0
POS 5/0
Loopback 0
Loopback 10
Loopback 20
Ethernet 1/1
Serial 2/0
192
IP address
192.168.1.1/24
1.1.1.1/32
3.3.3.3/32
10.1.1.1/32
192.168.1.2/24
192.168.2.2/24
10.110.3.1/24
10.110.4.1/24
192.168.2.1/24
2.2.2.2/32
4.4.4.4/32
10.1.1.1/32
10.110.6.1/24
10.110.4.2/24
Figure 56. (Details not