Enabling Pim-Sm - HP MSR ASM Configuration Manual

Determine the register suppression time.
•
• Determine the register probe time.
Determine the multicast traffic rate threshold, ACL rule, and sequencing rule for a switchover to SPT.
•
Determine the interval of checking the traffic rate threshold before a switchover to SPT.
•

Enabling PIM-SM

With PIM-SM enabled, a router sends hello messages periodically to discover PIM neighbors and
processes messages from the PIM neighbors. To deploy a PIM-SM domain, enable PIM-SM on all
non-border interfaces of the routers.
IMPORTANT:
All the interfaces on a device must be enabled with the same PIM mode.
Enabling PIM-SM globally on the public network
Step
1. Enter system view.
2. Enable IP multicast routing.
3. Enter interface view.
4. Enable PIM-SM.
Enabling PIM-SM in a VPN instance
Step
1. Enter system view.
2. Create a VPN instance and
enter VPN instance view.
3. Configure an RD for the VPN
instance.
4. Enable IP multicast routing.
5. Enter interface view.
6. Bind the interface with a VPN
instance.
7. Enable PIM-SM.
Command
system-view
multicast routing-enable
interface interface-type
interface-number
pim sm
Command
system-view
ip vpn-instance vpn-instance-name
route-distinguisher
route-distinguisher
multicast routing-enable
interface interface-type
interface-number
ip binding vpn-instance
vpn-instance-name
pim sm
61
Remarks
N/A
Disabled by default.
N/A
Disabled by default.
Description
N/A
N/A
For more information about this
command, see MPLS Command
Reference.
Not configured by default.
For more information about this
command, see MPLS Command
Reference.
Disabled by default.
N/A
By default, an interface belongs to
the public network, and is not
bound with any VPN instance.
For more information about this
command, see MPLS Command
Reference.
Disabled by default.