HP MSR ASM Configuration Manual page 171

Figure 47 Network diagram
Source
1.1.1.1/24
Configuration procedure
1. Assign an IP address and subnet mask to each interface according to
shown.)
2. On Router A, enable IP multicast routing, enable PIM-DM on each interface, and enable IGMP on
Ethernet 1/1.
<RouterA> system-view
[RouterA] multicast routing-enable
[RouterA] interface ethernet 1/1
[RouterA-Ethernet1/1] igmp enable
[RouterA-Ethernet1/1] pim dm
[RouterA-Ethernet1/1] quit
[RouterA] interface ethernet 1/2
[RouterA-Ethernet1/2] pim dm
[RouterA-Ethernet1/2] quit
3. Configure Switch A:
# Enable IGMP snooping globally.
<SwitchA> system-view
[SwitchA] igmp-snooping
[SwitchA-igmp-snooping] quit
# Create VLAN 100, assign Ethernet 1/1 through Ethernet 1/3 to this VLAN, and enable IGMP
snooping in the VLAN.
[SwitchA] vlan 100
[SwitchA-vlan100] port ethernet 1/1 to ethernet 1/3
[SwitchA-vlan100] igmp-snooping enable
[SwitchA-vlan100] quit
# Configure Ethernet 1/3 to be a static router port.
Eth1/2 Eth1/1
1.1.1.2/24 10.1.1.1/24
Router A
IGMP querier
Switch A
Eth1/1
Host C
Receiver
VLAN 100
159
Switch B
Switch C
Host A
Receiver
Host B
Figure 47. (Details not