Configuration Procedure - HP MSR ASM Configuration Manual

Configuration procedure

1. Configure IPv6 addresses for router interfaces as shown in
2. Configure OSPFv3. (Details not shown.)
3. Enable IPv6 multicast routing, IPv6 PIM-SM and MLD, and configure an IPv6 PIM-SM domain
border:
# Enable IPv6 multicast routing on Router A, and enable PIM-SM on each interface.
<RouterA> system-view
[RouterA] multicast ipv6 routing-enable
[RouterA] interface ethernet 1/1
[RouterA-Ethernet1/1] pim ipv6 sm
[RouterA-Ethernet1/1] quit
[RouterA] interface pos 5/0
[RouterA-Pos5/0] pim ipv6 sm
[RouterA-Pos5/0] quit
The configuration on Router B and Router D is similar to the configuration on Router A.
# Enable IPv6 multicast routing on Router C, enable IPv6 PIM-SM on each interface, and enable
MLD on the host-side interface Ethernet 1/1.
<RouterC> system-view
[RouterC] multicast ipv6 routing-enable
[RouterC] interface serial 2/0
[RouterC-Serial2/0] pim ipv6 sm
[RouterC-Serial2/0] quit
[RouterC] interface serial 2/1
[RouterC-Serial2/1] pim ipv6 sm
[RouterC-Serial2/1] quit
[RouterC] interface ethernet 1/1
[RouterC-Ethernet1/1] pim ipv6 sm
[RouterC-Ethernet1/1] mld enable
[RouterC-Ethernet1/1] quit
# Configure an IPv6 PIM domain border on Router A.
[RouterA] interface pos 5/0
[RouterA-Pos5/0] pim ipv6 bsr-boundary
[RouterA-Pos5/0] quit
# Configure an IPv6 PIM domain border on Router B.
[RouterB] interface pos 5/0
[RouterB-Pos5/0] pim ipv6 bsr-boundary
[RouterB-Pos5/0] quit
4. Configure the position of C-BSR and C-RP:
# Configure the position of C-BSR and C-RP on Router A.
[RouterA] pim ipv6
[RouterA-pim6] c-bsr 1001::1
[RouterA-pim6] c-rp 1001::1
[RouterA-pim6] quit
# Configure the position of C-BSR and C-RP on Router B.
[RouterB] pim ipv6
Figure
435
110. (Details not shown.)