HP MSR ASM Configuration Manual page 428

group command to display information about MLD snooping groups and MLD multicast groups. For
example:
# Display information about MLD snooping groups on Switch A.
[SwitchA] display mld-snooping group
Total 1 IP Group(s).
Total 1 IP Source(s).
Total 1 MAC Group(s).
Port flags: D-Dynamic port, S-Static port, C-Copy port, P-PIM port
Subvlan flags: R-Real VLAN, C-Copy VLAN
Vlan(id):100.
Total 1 IP Group(s).
Total 1 IP Source(s).
Total 1 MAC Group(s).
Router port(s):total 1 port(s).
Eth1/1
IP group(s):the following ip group(s) match to one mac group.
IP group address:FF1E::101
(::, FF1E::101):
Host port(s):total 2 port(s).
Eth1/3
Eth1/4
MAC group(s):
MAC group address:3333-0000-0101
Host port(s):total 2 port(s).
Eth1/3
Eth1/4
# Display information about MLD multicast groups on Router A.
[RouterA] display mld group
Total 1 MLD Group(s).
Interface group report information
Ethernet1/1(2001::1):
Total 1 MLD Group reported
Group Address: FF1E::1
Last Reporter: FE80::2FF:FFFF:FE00:1
Uptime: 00:00:03
Expires: 00:04:17
When Host A leaves the IPv6 multicast group, it sends an MLD done message to Switch A. Receiving the
message, Switch A removes port Ethernet 1/3 from the member port list of the forwarding entry for the
group. However, it does not remove the group or forward the done message to Router A because Host
B is still in the group. Use the display mld-snooping group command to display information about MLD
snooping groups. For example:
# Display information about MLD snooping groups on Switch A.
[SwitchA] display mld-snooping group
Total 1 IP Group(s).
Total 1 IP Source(s).
Total 1 MAC Group(s).
(D) ( 00:01:23 )
(D)
(D)
416