HP MSR ASM Configuration Manual page 305

Figure 81 Network diagram
Configuration procedure
1. Enable IPv6 forwarding on each router and assign an IPv6 address and prefix length to each
interface according to
2. Enable IPv6 multicast routing, IPv6 PIM-DM, MLD, and MLD proxying:
# Enable IPv6 multicast routing on Router A, IPv6 PIM-DM on Serial 2/1, and MLD on Ethernet
1/1.
<RouterA> system-view
[RouterA] multicast ipv6 routing-enable
[RouterA] interface serial 2/1
[RouterA-Serial2/1] pim ipv6 dm
[RouterA-Serial2/1] quit
[RouterA] interface ethernet 1/1
[RouterA-Ethernet1/1] mld enable
[RouterA-Ethernet1/1] pim ipv6 dm
[RouterA-Ethernet1/1] quit
# Enable IPv6 multicast routing on Router B, MLD proxying on Ethernet 1/1, and MLD on Ethernet
1/2.
<RouterB> system-view
[RouterB] multicast ipv6 routing-enable
[RouterB] interface ethernet 1/1
[RouterB-Ethernet1/1] mld proxying enable
[RouterB-Ethernet1/1] quit
[RouterB] interface ethernet 1/2
[RouterB-Ethernet1/2] mld enable
[RouterB-Ethernet1/2] quit
Verifying the configuration
Use the display mld interface command to display the MLD information on an interface. For example,
# Display MLD information on Ethernet 1/1 of Router B.
[RouterB] display mld interface ethernet 1/1 verbose
Ethernet1/1(2001::2):
MLD proxy is enabled
Figure 81. (Details not shown.)
293