HP MSR ASM Configuration Manual page 47

Figure 16 Network diagram
Table 6 Interface and IP address assignment
Device
Source 1
Source 2
Router A
Router A
Router A
Router B
Router B
Router B
Configuration procedure
1. Assign IP addresses and configure unicast routing:
a. Assign an IP address and subnet mask to each interface according to
shown.)
b. Configure OSPF on the routers in the PIM-SM domain to make sure they are interoperable at
the network layer and they can dynamically update their routing information. (Details not
shown.)
2. Enable IP multicast routing, enable PIM-SM on each interface, and enable IGMP and IGMP SSM
mapping on the host-side interface:
# Enable IP multicast routing on Router D, enable PIM-SM on each interface and enable IGMPv3
and IGMP SSM mapping on Ethernet 1/1.
<RouterD> system-view
[RouterD] multicast routing-enable
[RouterD] interface ethernet 1/1
[RouterD-Ethernet1/1] igmp enable
[RouterD-Ethernet1/1] igmp version 3
[RouterD-Ethernet1/1] igmp ssm-mapping enable
[RouterD-Ethernet1/1] pim sm
[RouterD-Ethernet1/1] quit
Interface IP address
— 133.133.1.1/24
— 133.133.2.1/24
Eth1/1 133.133.1.2/24
Eth1/2 192.168.1.1/24
Eth1/3 192.168.4.2/24
Eth1/1 133.133.2.2/24
Eth1/2 192.168.1.2/24
Eth1/3 192.168.2.1/24
Device Interface
Source 3 —
Receiver —
Router C Eth1/1
Router C Eth1/2
Router C Eth1/3
Router D Eth1/1
Router D Eth1/2
Router D Eth1/3
35
IP address
133.133.3.1/24
133.133.4.1/24
133.133.3.2/24
192.168.3.1/24
192.168.2.2/24
133.133.4.2/24
192.168.3.2/24
192.168.4.1/24
Figure 16. (Details not