HP MSR ASM Configuration Manual page 448

[RouterB-pim6] c-bsr 1001::2
[RouterB-pim6] c-rp 1001::2
[RouterB-pim6] quit
5. Configure BGP, and specify the IPv6 MBGP peer:
# On Router A, configure the IPv6 MBGP peer.
[RouterA] ipv6
[RouterA] bgp 100
[RouterA-bgp] router-id 1.1.1.1
[RouterA-bgp] ipv6-family
[RouterA-bgp-af-ipv6] peer 1001::2 as-number 200
[RouterA-bgp-af-ipv6] import-route direct
[RouterA-bgp-af-ipv6] quit
[RouterA-bgp] ipv6-family multicast
[RouterA-bgp-af-ipv6-mul] peer 1001::2 enable
[RouterA-bgp-af-ipv6-mul] import-route direct
[RouterA-bgp-af-ipv6-mul] quit
[RouterA-bgp] quit
# On Router B, configure the IPv6 MBGP peers and redistribute OSPF routes.
[RouterB] ipv6
[RouterB] bgp 200
[RouterB-bgp] router-id 2.2.2.2
[RouterB-bgp] ipv6-family
[RouterB-bgp-af-ipv6] peer 1001::1 as-number 100
[RouterB-bgp-af-ipv6] import-route ospfv3 1
[RouterB-bgp-af-ipv6] quit
[RouterB-bgp] ipv6-family multicast
[RouterB-bgp-af-ipv6-mul] peer 1001::1 enable
[RouterB-bgp-af-ipv6-mul] import-route ospfv3 1
[RouterB-bgp-af-ipv6-mul] quit
[RouterB-bgp] quit
6. Verify the configuration:
Use the display bgp ipv6 multicast peer command to display IPv6 MBGP peers on each router. This
example uses Router B.
[RouterB] display bgp ipv6 multicast peer
BGP local router ID : 2.2.2.2
Local AS number : 200
Total number of peers : 3
Peer AS
1001::1 100
1001::1 100
MsgRcvd MsgSent OutQ PrefRcv Up/Down
56 56
56 56
436
Peers in established state : 3
0 0 00:40:54 Established
0 0 00:40:54 Established
State