Web-Based Ip Configuration - Hirschmann RS20 User Manual

Entering the IP Parameters

2.8 Web-based IP Configuration

With the Basic Settings:Network dialog you define the source from
which the device gets its IP parameters after starting, and you assign the IP
parameters and VLAN ID and configure the HiDiscovery access.
Figure 16: Network Parameters Dialog
Under "Mode", you enter where the device gets its IP parameters:
In the BOOTP mode, the configuration is via a BOOTP or DHCP
server on the basis of the MAC address of the device
"Setting up a DHCP/BOOTP
In the DHCP mode, the configuration is via a DHCP server on the
basis of the MAC address or the name of the device
"Setting up a DHCP Server with Option
In the "local" mode the net parameters in the device memory are used.
50
2.8 Web-based IP Configuration
Server").
82").
(see page 218
(see page 224
Basic Configuration
Release 6.0 07/2010