Hirschmann RS20 User Manual page 45

Entering the IP Parameters 2.5 System configuration via BOOTP
Note: The loading process started by DHCP/BOOTP (see on page 218
"Setting up a DHCP/BOOTP Server") shows the selection of "from URL &
save locally" in the "Load" frame. If you get an error message when saving a
configuration, this could be due to an active loading process. DHCP/BOOTP
only finishes a loading process when a valid configuration has been loaded.
If DHCP/BOOTP does not find a valid configuration, then finish the loading
process by loading the local configuration in the "Load" frame.
Basic Configuration
45
Release 6.0 07/2010