Hirschmann RS20 User Manual page 273

Delivery condition: Autonegotiation activated except for the ring ports:
100 Mbit/s, full duplex.
The socket housing is electrically connected to the front panel.
The PoE voltage is fed in via the pins 1&4 onto the data signal line pairs
(phantom supply).
Pole Wire color
White-orange
White-green
Orange
Green
Housing: shield
Fig. 9: Pin assignment of the TP/TX interface for PoE for supply via the data
signal line pairs (M12 socket).
V Connect the data lines according to your requirements.
V Use shielded CAT5 cable.
V Use a shielded 4-pin M12 connector.
V Apply the shield of the cable onto the housing of the connector.
Patch cables for operating the OCTOPUS are illustrated in the figure above
(see Fig. 8).
100 Mbit/s F/O connection (MicroFX)
U
100 MBit/s F/O ports enable the connection of terminal devices or inde-
pendent network segments in compliance with the IEEE 802.3
100BASE-FX standard. These ports support:
D
full duplex mode
Pin Function
Fig. 10: Pin assignment of a MicroFX socket
OCTOPUS 8M/16M/24M
Release 07/2008
Function
TX+
Transmit Data +
RX+
Receive Data +
TX- Transmit Data -
RX- Receive Data -
Not connected
RX (Receive Data)
Not connected
TX (Transmit Data)
PoE(PSE)
+
-
+
-
21