Assembly And Startup Procedure; Device Installation; Unpacking And Checking; Connecting The Connector For Supply Voltage And Signal Contact - Hirschmann RS20 User Manual

2

Assembly and startup procedure

The device has been developed for practical application in a harsh industrial
environment. Accordingly, the installation process has been kept simple.
On delivery, the device is ready for operation.
The following procedure is appropriate for assembly:
D

Unpacking and checking

D

Connecting the connector for supply voltage and signal contact

D
Fitting the device, grounding
D
Fitting the connector for the power supply, startup procedure
D
Connecting the data lines
2.1

Device installation

2.1.1 Unpacking and checking
V Check whether the package was delivered complete
see "Scope of delivery" on page
V Check the individual parts for transport damage.
2.1.2 Connecting the connector for supply voltage and
signal contact
The supply voltage and the signal contacts are connected via a 5-pole M12
circular connector (A coding, e.g. ELWIKA 5012 PG7 from Hirschmann
included in scope of delivery).
24V supply voltage
U
The supply voltage can be connected redundantly. Both inputs are
uncoupled. With redundant supply, the transformer supplies the device
alone with the higher output voltage. The supply voltage is electrically
isolated from the housing.
Note: With non-redundant supply of the mains voltage, the device reports
a power failure. You can prevent this message by applying the supply
voltage over the two inputs or by changing the configuration via manage-
ment.
12
28.
OCTOPUS 8M/16M/24M
Release 07/2008