Hirschmann RS20 User Manual page 34

Entering the IP Parameters
Set up a connection to the device
Command Line
The start screen appears.
NOTE: Enter '?' for Command Help. Command help displays all options
that are valid for the 'normal' and 'no' command forms.
the syntax of a particular command form, please consult the
documentation.
(Hirschmann PowerMICE) >
Deactivate DHCP.
Enter the IP parameters.
Local IP address
On delivery, the device has the local IP address 0.0.0.0.
Netmask
If your network has been divided up into subnetworks, and if these are
identified with a netmask, then the netmask is to be entered here.
The default setting of the netmask is 0.0.0.0.
IP address of the gateway
This entry is only required if the device and the management station or
tftp server are located in different subnetworks
"Example of how the network mask is
Enter the IP address of the gateway between the subnetwork with the
device and the path to the management station.
The default setting of the IP address is 0.0.0.0.
Save the configuration entered using
copy system:running-config nvram:startup-config.
34
Interface").
2.2 Entering IP parameters via CLI
(see on page 18 "Opening the
(see page 30
used").
For
Basic Configuration
Release 6.0 07/2010