Ericsson RBS 2106 Reference Manual page 388

Operation and Maintenance Terminal
Read
Install
Cable mounting list
Site specific data
Save
Open
Inventory list
Configure
Reconfigure
Modify
The functions above are for general purpose use.
48.3.5 External Alarms
The following user functions, related to the external alarms, are
available in the OMT:
•
•
•
The output can be displayed or directed to file (output stored in a file on
the OMT).
The functions above are normally used at
•
•
The fault status for all inlets defined for auxiliary faults can be
monitored.
386 (485)
Display external alarm setup, display the external alarm setup
parameters (see chapter External Alarms) associated with each of
the external alarm inputs
Define external alarm setup
Monitor external alarms status, the status (on/off) of the external
alarms is continuously monitored and displayed
installation (display/define external alarm setup)
site acceptance (monitor external alarms status)
© Ericsson Radio Systems AB
— All Rights Reserved —
Copy the IDB from the RBS to the OMT.
Install the IDB from the RBS to the OMT.
Display a cable mounting list based upon
information from the IDB.
Site specific data , that is IDB information
that is changeable from the OMT, is
displayed, copied to any file medium to
the IDB in the OMT.
Copy the IDB from the OMT to any file
medium, for example a floppy disk or a
hard disk.
Copy the IDB from any file medium to
the OMT.
An inventory list, containing RU data,
based upon information from the IDB, is
displayed, saved on file medium or
printed.
Generate a new configuration.
Copy data from the old IDB to the new.
Increase or decrease the number of
activated RUs in the IDB.
EN/LZT 720 0008 P2A
2001-11-28